Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 19 (kliknij aby zobaczyć)
132990430.qxd 01/04/2004 13:29 Pagina 19
Emergency emptying out
If the water is not discharged, proceed as follows to empty out the machine: � pull out the plug from the power socket; � close the water tap; � if necessary, wait until the water has cooled down; � open the pump door; � place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. Empty the bowl. Repeat the procedure until water stops flowing out; � clean the pump guard if necessary as previously described; � replace the emergency emptying hose in its seat after having plugged it; � screw the drain filter fully in and close the door.
The dangers of freezing
If the machine is installed in a place where the temperature could drop below 0°C, proceed as follows: � Remove the plug from the socket. � Close the water tap and unscrew the water inlet hose from the tap. � Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out. � Screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again. By doing this, any water remaining in the machine is removed, avoiding the formation of ice and, consequently, breakage of the affected parts. When you use the machine again, make sure that the ambient temperature is above 0°C. Important! Every time you drain the water through the emergency emptying hose you must pour 2 litres of water into the main wash compartment of the detergent drawer and then run the drain programme. This will activate the ECO valve avoiding that part of the detergent remains unused with your next washing.
