Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 29 (kliknij aby zobaczyć)
3. Remove both plastic caps sideways.
3
Special spanner A and sealing caps B (2 off) and C (1 off) are supplied with the appliance. 4. Remove screw D with its compression spring using special spanner A. 5. Turn sealing cap C upside down as shown in the illustration. 6. Seal hole using sealing cap C.
7. Unscrew and remove two screws E using special spanner A. 8. Unscrew and remove four screws F using special spanner A. 9. Remove transit bar G. 10. Screw in the four screws F again. 11. Seal the two big holes using sealing caps B. Important! Press all sealing caps B (2 off) and C (1 off) in firmly, so that they snap into place. (Splash protection).
Where to install
Important! The appliance must not be used in a room where there is a danger of frost. Frost damage or impaired operation! Frost damage is not covered by the warranty. � The surface on which the appliance is to be installed must be firm and level. Do not install the appliance on carpets or on soft floor coverings.
