Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 3 (kliknij aby zobaczyć)
Operation
Vent Control ENERGY SAVER (HIGH, MED and LOW) ENERGY SAVER mode provides the most energy efficient use of your room air conditioner. In ENERGY SAVER mode, the fan stops when the compressor stops cooling. This feature can be used with SMART COOL or cooling with any fan speed. Amana� new air sampling system works to maintain set s temperature within 1.5°F while in ENERGY SAVER mode. Approximately every 5 minutes the fan will turn on and � sample�the room air to determine if cooling is needed. If the room is cool enough, the fan will cycle off. If the room needs further cooling, the compressor will start along with the fan until the set temperature is reached. ENERGY SAVER has a soft start fan feature. This feature starts the fan in low speed to reduce noise.
QUIET ZONE
EXHAUST CLOSED
Open or close the vent by sliding the vent control lever to the appropriate setting. EXHAUST - This setting opens the vent to move indoor air out. Note: To conserve energy, the unit should be set to the FAN ONLY mode when using this setting. CLOSED - In this position the vent is closed and room air is recirculated and filtered. This position should be used for all normal cooling operations (see underlined cooling options on control panel). Unit Control
FAN ONLY - FAN ONLY circulates room air at the set fan speed without cooling. This feature can be turned off by pressing the FAN ONLY, the SMART COOL, or the ENERGY SAVER button. Indoor temperature is displayed in FAN ONLY mode.
OFF
SMART COOL
LOW FAN
MED FAN
COOLING
HIGH FAN
ENERGY SAVER
FAN ONLY
SET
DELAY TIMER
QUIET ZONE
EXHAUST CLOSED
Control Panel
OFF - Completely shuts off the unit. SMART COOL - SMART COOL adjusts the fan speed of the unit to achieve the selected temperature. The SMART COOL feature uses computer logic to cool the room quickly and quietly. The fan speed starts on high, automatically switches to medium, and finally goes to low as the room temperature nears the set temperature. LOW FAN, MED FAN, HIGH FAN - These three buttons are used to select either a low, medium or high fan speed to cool. If FAN ONLY is selected these buttons change fan speed without cooling. Selecting the fan speed starts normal cooling. SET Temperature - These key pads increase or decrease the set temperature.
DELAY TIMER - This button provides a means of delaying the start up or shut down of the air conditioner from 1 to 24 hours from the present time. After setting the delay timer, the displayed time will countdown to unit start or stop. See next page for details.
Brightness Adjust Feature (some models) - Display brightness can be changed using the � or � up� down�keypad. To decrease brightness, simultaneously press and hold OFF pad with � down� arrow. To increase brightness, simultaneously press and hold OFF pad with � arrow. up�
