2. Power Switch Use this switch to turn the unit on and off. Place the switch in the �I� position to turn the unit on and �O� position to turn the unit off. 3. Fuse The fuse is located within the cap of the fuseholder. If the fuse should fail, IT MUST BE REPLACED WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY. If the amp repeatedly blows, it should be taken to a qualified service center for repair. WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED FROM ITS POWER SOURCE. 4. Parallel Line Inputs These two jacks are provided to supply a single input signal to the 112 PM and to allow for daisychaining the signal to possibly another 112 PM or amp/monitor combination. Do not attempt to apply two different signals to the Parallel Line Inputs. Use the second jack only as a parallel output to another unit. 5. Full Range Output The Full Range Output is a post EQ, powered output. Designed for a minimum impedance of 8 ohms, this output should be connected only to non-powered monitor enclosures. The Peavey 112M is the perfect extension monitor to use in this application. 6. Four-Band Graphic EQ Use this Four-Band Graphic EQ to cut or boost your signal up to 12 dB at the designated frequency centers. This is especially useful for reducing low frequency rumble or feedback that often occurs on stage. 7. Level The Level control adjusts the overall volume of the amplified signal. Therefore, by adjusting the Level control of the 112 PM you also adjust the level of any monitor(s) connected to the Full Range Output (5).
