Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
1.
CONNECT THE TV-VIDEO COMBI
Placing the batteries in the remote control
a Open up the battery compartment of your remote control
Important for the United Kingdom
This apparatus is fitted with an approved moulded 13 Amp plug. To change a fuse in this type of plug proceed as follows:
a Remove fuse cover and fuse. b Fix new fuse which should be a BS1362 5A, A.S.T.A. or
and place the batteries in it as shown in the picture.
BSI approved type.
c Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5A. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5A. D Note: * The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere. How to connect a plug: The wires in the mains lead are coloured in accordance with the following code: BLUE - �NEUTRAL� (�N�) BROWN - �LIVE� (�L�)
d The BLUE wire must be connected to the terminal which
b Close the battery compartment.
is marked with the letter �N� or coloured BLACK.
e The BROWN wire must be connected to the terminal
which is marked with the letter �L� or coloured RED.
f Do not connect either wires to the earth terminal in the
plug which is marked with the letter �E� or by the safety earth symbol \or coloured green or green-and-yellow. Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not imply over the two wires.
