How can I set the counter to '0:00:00'? You can set the counter to '0:00:00' with CLEAR . When you put a cassette in the TV-Video Combi, the counter will automatically reset to '0:00:00'. The counter does not move This occurs when there are no recordings on a portion of a tape. This is not a fault in your TV-Video Combi. The screen shows '-0:01:20' If you rewind a cassette from the tape position '0:00:00', the counter will show for instance, '-0:01:20' (the cassette was rewound to 1 minute and 20 seconds before '0:00:00'). '-:--' is displayed in the 'REM' counter This counter will automatically recognise the length of the tape. In addition, when you put in a cassette the TV-Video Combi must first calculate the time played. Therefore, '-:--' appears first and only after the tape has been running for a few seconds, the correct playing time will be shown.
Still picture
1.During playback, press 1.
STILL 2
to stop the
tape and display a still picture. . Scanning and still motion interferes with the picture quality. The sound is switched off. This is not a fault in your TV-Video Combi.
2.To continue playback, press 2.
PLAY B-K
Searching for tape position without picture (forward wind and rewind)
1.Stop the tape with STOP C-L . 1. 2.Press REW0- s (reverse) or 2.
(forward). 3.To stop the tape, press 3.
FWD 1- B
STOP C-L
.
Index search
Every time a tape is recorded, an index mark is written on the tape. These marked positions can be found again quickly and easily later.
Searching for a tape position with picture (scanning)
1.While a cassette is playing, press 1.
(reverse) or times.
FWD 1- B REW0- s
1.To search for the previous marking, press 1.
INDEX
(forward) one or more
2.Press 2.
PLAY B-K
to resume playback.
and then REW0- s . 2.For the next marking, press INDEX and then 2. FWD 1- B . 3.As soon as the TV-Video Combi finds this marking, 3. it automatically switches to playback.
Manual Tracking
To adjust the tracking manually, press P+ or P- on the TV-Video Combi during playback. Tracking returns to Automatic Tracking Adjustment when you press STOP C-L or insert a tape.
6. Manual recording
General information
Use 'Manual Recording' to make a spontaneous recording (for example, a programme currently being shown). If you want to start and stop a recording manually, read the section 'Recording without automatic switch-off'. If you want to start a recording manually but have it stopped automatically, read the section 'Recording with automatic switch-off'. (e.g. not to record to the end of the tape) Read the section 'Automatic recording from a satellite receiver', if you want a recording to be controlled automatically by a satellite receiver.
Recording without automatic switch-off
1.Insert a cassette. 1. 2.Use PROG P+ PROG P� or 2.
to select the programme number you want to record, for example, 'P01'.
REC I 0..9
