THE MACKIE FIXER � MACKIE DESIGNS SERVICE NEWS
To make Aux 3/5 and Aux4/6 Pre-EQ and Pre-Fader Aux 3/5 1. Cut the trace between the round and square pads at point D on the channel to be modified. 2. Solder an insulated jumper wire from the square pad at D to the square pad at F on the same channel. 3. Repeat for other channels as required. Aux 4/6 1. Cut the trace between the round and square pads at point E on the channel to be modified. 2. Solder an insulated jumper wire from the square pad at E to the square pad at F on the same channel. 3. Repeat for any other channels as required. To make Aux 3/5 and Aux4/6 Post-EQ and Pre-Fader Aux 3/5 1. Cut the trace between the round and square pads at point D on the channel to be modified. 2. Solder an insulated jumper wire from the square pad at D to the square pad at B on the same channel. 3. Repeat for other channels as required. Aux 4/6 1. Cut the trace between the round and square pads at point E on the channel to be modified. 2. Solder an insulated jumper wire from the square pad at E to the square pad at B on the same channel. 3. Repeat for any other channels as required.
bottom of main board
Area of interest for one channel. (Move along the board sideways to do the other channels)
