PHILIPS 20PV184/05
Instrukcja Obsługi

&

Programming with �VIDEOPlus+�
All the information required for programming is encoded in the �VIDEOPlus+� code.
1 2

Selecting a TV channel
Select the required TV channel (= programme number) with the
Pp

button or the

0-9

but-

Press the

SV/V+

button on the remote control.

Enter the entire �VIDEOPlus+ code�. This code (up to 9 digits) is found next to the start time of a TV programme in your TV guide. If you entered an incorrect code number, clear it with the
CLEAR

tons on the remote control. The selected programme number (e.g.: �P 01� ) appears in the upper right corner of the TV screen.

button.

3

If you want to repeat programming at daily or weekly intervals, select the required settings in the �DAILY/WEEKLY� line. �Daily� programming can only be used for recordings to be made from Mondays to Fridays inclusive.

Volume control
You can control the volume level with the
Sp

button.
MUTE y

4

After confirming the corresponding data appears on the TV screen.

If you want to mute the sound temporarily (e.g.: during a telephone call), press the

but-

ton on the remote control. When you press it again, the sound returns at the same volume level.

Note: If you use VIDEOPlus+ for the first time, the �PROGRAMME NR.� line appears when you enter the VIDEOPlus+ code. Enter the required programme number.
5

Picture control
You can control brightness, contrast, sharpness and colour here. 1 Press the MENU button.
2 3

Confirm with the

OK

button.

The data has been stored in a TIMER block. Please ensure that you loaded a cassette without erase protection.
6

Press the

STANDBY m

button.

Select and confirm the line �PICTURE� . Select and confirm the TV screen setting.

How to enter, check or clear a TIMER-block manually
Note: In addition, you can adjust the tint for the playback of cassettes in the NTSC standard.
1 2 3 4

Press the

TIMER k

button.

Select a free TIMER block or the TIMER block you want to check or clear. Clear: Press the CLEAR button. Enter/Check: Press the D or C button to switch between �DATE� (date), �DW� (daily, weekly), �PR� (programme number), �START� (start time) and �END� (end time). Press the A and the B or the 0-9 buttons to change the data.

5 6

To end programming, press the Press the STANDBY m button.

MENU

button.