Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 24 (kliknij aby zobaczyć)
Section 3
Detailed Parameters
Sensitivity -20-+20dB
220i
The AFS algorithm is very effective when the audio has a nominal level of 0 dBu, however if the audio is too low in level the AFS algorithm may not catch feedback as quickly as possible. By increasing or decreasing the sensitivity you can adjust for audio that is either too loud or too soft and help the AFS function properly.
3.4 - Automatic Gain Control (AGC)
The AGC is used to keep the average level of a signal at a constant level. This is done by selecting a desired Target output level and Window. The AGC keeps the signal within the Window about the selected Target by slowly adjusting the gain. The maximum gain that can be applied to the signal is selected by the Gain parameter. When the input signal falls below the Low Threshold the AGC releases the gain and returns to unity. This prevents the AGC from adding gain when there is no signal present and raising the system noise floor. High level signals are reduced by a fast limiter to prevent distortion by clipping. The AGC Threshold meters show what region of the AGC the input signal is in. The T (yellow) indicates the signal is within the Window. A + (red) indicates the signal is going into the Limiter. A � (green) indicates the AGC is adding adding Gain and is at or below the window. When the Threshold meter is off the signal is below the Low Threshold.
AGC: On/Off
Turns the AGC module On and Off.
Target: -20 to 20 dB
The Target parameter defines where you would like the average level of the AGC output to be. If the average level of the signal rises above the Target the gain will be reduced. For signals with an average level below the Target the gain will be increased.
Gain: 1 to 20dB
This adjusts the maximum amount of gain that can be added by the AGC.
Window: 1 to 10dB
This adjusts the amount of variation in the output
®
