TOSHIBA 28H56G
Instrukcja Obsługi

Switching the TV ON/OFF
You can operate your TV either using the remote control handset or directly using the TV onset buttons.

1- Select LANGUAGE with �P � or �P � button, then press the � � or � � button to select a menu language. 2- Select COUNTRY with �P � or �P � button, then press the � � or � � button to select the correct country. 3- Select START with �P � or �P � button, then press OK button to start APS. APS, (Automatic Programming System) automatically programmes the received channels in your TV�s programme numbers. During APS, �APS IS RUNNING PLEASE WAIT� message will be displayed. After APS is finalized, the �PROGRAM TABLE� appears. To cancel APS, press the �EXIT� button.
@Y@8VUDPI�6QT

To switch the TV on
Your TV will switch on in two steps: 1- Press the power button located on the front of the TV. Then the TV switches itself to standby mode and the BLUE LED located on the front of theTV turns on. 2- To switch on the TV from stand-by mode either: Press a digit button on the remote control so that a programme number is selected, or, � Press or button on the side of the TV or P or P button on the remote control, so that the last switched off programme is selected. Either way the TV will switch on and the LED will turn off.

�

6QT��DT��SVIIDIB��QG@6T@��X6DU�

QSPBS@TT 8C6II@G������� @YDU�����86I8@G 

"$�

IMPORTANT:
� If no aerial signal is received at the selected programme for a period of 5 minutes then your TV automatically switches into stand-by mode.

To switch the TV off
� Press the stand-by button on the remote control, so the TV will switch to stand-by mode and the LED will become BLUE, or, � Press the power button located on the front of the TV, so the TV will switch off. NOTE: If you have switched off the TV set from the power button instead of the remote control, next time you press the power button, the TV set will switch on without going to the stand-by mode.

Operating with the onset buttons
Volume setting and programme selection can be made using the buttons on the right side of the TV.

Volume Setting and Programme Selection
� Press �� to decrease volume or � crease volume. � Press press +� to in-

Initial Settings
The message �PLEASE CHECK ANTENNA CABLE!� will be displayed when you turn on your TV for the first time.
@Y@8VUDPI�6QT

to decrease the channel position by one, to increase the channel position by one.

Entering Main Menu
� Press �MENU� button to enter the menu. In the menu select sub-menu using � +� or �� buttons and enter the submenu using � � button. In the submenu select the desired item by using � � or � � buttons and to change or adjust it using � +� or �� buttons. To learn the usage of the menus, refer to the Menu System section.

�
QG@6T@��8C@8F��6IU@II6��867G@�

G6IBV6B@ 8PVIUS` TU 6SU

@IBGDTC VF

@YDU�����86I8@G

Note: If you connect Video Recorder to your TV via antenna input (ANT socket); to tune the VCR channel automatically you must set the VCR in play mode before you start APS.

Operating with Remote Control
The remote control handset of your TV is designed to control all the functions of the model you selected. The

ENGLISH - 7 A01-28H56G&ENG-28420-1700UK-AK53-ST7P-PLLCH-50076937-10035966.p65 7 21.02.2006, 11:58