ow that you have looked up the four-digit remote-control Direct-entry Code for your brand of accessory device, you are ready to follow the simple steps shown below to program your TV remote. Please read through all the steps before beginning.
Cable Converter Box
1
First, press and hold down the VCR or ACC (for an accessory device other than a VCR) mode button on the TV remote. Then press and hold down the MENU/SELECT button at the same time for a brief moment. Release the buttons. The TV remote back light will switch on. NOTE: For correct operation, you must first press and hold the mode button and then press and hold the MENU/SELECT button simultaneously. Within 30 seconds of pressing the VCR (or ACC) button and MENU/SELECT button, enter a four-digit code for the accessory device (see pages 52 and 53). If you make a mistake while attempting to enter the four-digit code and want to start again, press any button other than one with a number. Then return to step 1 to begin again.
DVD Player
VCR
2
1 3 1 2
3
Point the remote at the accessory device. Then press the POWER button on the remote to turn the device on.
HELPFUL HINT
If you do not enter a complete code within 30 seconds, you will need to perform step 1 of the Code-entry Method again. If the procedure explained above does not work the first time, repeat the steps using the same remote code number. If after repeated attempts the Code-entry Method does not allow you to work your accessory device with your TV remote, try the Search Method explained on the next page.
