It is important to prepare your refrigerator for use. This section tells you how to clean it, connect it to a power source, install it and level it.
Cleaning
Removing
your
packaging
refrigerator
materials
NOTE: Do not remove any permanent . I. instruction labels inside your rerngeraror. uo not remove the Tech Sheet fastened under the refrigerator at the front.
Remove tape and any inside labels (except the model and serial number label) before using the refrigerator. To remove any remaining glue: l Rub briskly with your thumb to make a ball, then remove. OR
l
Cleaning
it before
use
After removing all packaging materials, clean your refrigerator before using it, if necessary. See cleaning instructions on pages 13 and 14.
Soak area with liquid hand-dishwashing detergent before removing glue as described above. Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners. These can damage the material. See �Important Safety Instructions� on page 3.
Plugging
it in
Recommended Grounding Method A 220 Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.
