Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
2
1-2-3 HDTV - 1 Getting Connected Cable Box with RF Output
Connect the incoming cable TV signal to the CABLE IN jack on the back of the cable box.
B
1 2 3
Incoming Cable TV Signal
Back of Cable Box (example only)
Connect a coaxial cable (not supplied) to the TO TV jack on the back of the cable box and to the CABLE jack on the back of the TV. Set the Output Channel switch on the back of the cable box to CH 3 or 4 (whichever is correct for your cable box), then tune the TV to the corresponding channel. Once tuned, change channels at the cable box, not the TV.
NOTE: This connection will not supply stereo sound to the TV. The reason is that the RF output on a cable box�labeled �TO TV,� �OUT,� or �OUTPUT,� for example�will not send a stereo signal to the tuner (VHF/UHF) input on a TV.
