Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 11 (kliknij aby zobaczyć)
Changing the "Patch Call" Method
In normal operation, the sound of the 606 will change immediately if a patch is selected in play mode. This may be undesirable if a patch from a distant memory location is called and the sound of other unwanted patches in between is heard. If desired, you can change the "Patch call"
Changing the "Patch Call" Method
method from direct selection to the pre-select method. In pre-select mode, you first specify the desired patch and then confirm the selection. The sound will only change after you have confirmed the operation.
Changing the "Patch call" method to pre-select
To change the "Patch call" method to preselect, you must turn the unit on while holding down the [Q] foot switch.
Confirm the patch change
When the desired patch is shown, press the [W]/[Q] foot switches together.
A3
A3
Confirm
Specifying the desired patch
Use the [W]/[Q] foot switches to select the patch you want to use next.
You can also use the VALUE [+]/[-] keys to only switch the bank. The patch change is confirmed, the sound changes, and the display stops flashing and stays constantly lit.
Changing the "Patch Call" Method
Changing the "Patch Call" Method
A1
A2
A3
The bank and patch number of the patch to be used next will be shown on the display, but the sound does not yet change.
Changing the "Patch call" method back to direct select
To change the "Patch call" method back to normal direct select operation, simply turn the unit off and back on again.
This will return the patch select method to the default setting.
ZOOM 606
GUITAR
