jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 30 (kliknij aby zobaczyć)
64LHP5000 PROJECTOR UNIT
10 -2
Green line adjustment
1st FAC
� Adjustment in the vertical direction
Start » Vertical correction adjustment of the green line
� Select the Adjustment item
GV - STATIC
� Adjust the Data value
Note : � Repeat the adjustments until you attain the optimum state. � Fine-adjust over the entire picture to obtain the optimum picture. � If the adjustment of V-STATIC is not possible within the range of 010 to �010, set the data value to 0, turn the centering magnet of the deflection yoke and fine-adjust V-STATIC. Screen No. Adjustment Method � Adjust the center horizontal line to the center of the screen.
or
or
In particular, be aware of the setting before adjustment.
� Adjust so that the green vertical line at the center becomes a straight line with neither distortion nor tilting.
(GV-4D BOW)
"
(GV-5D SKEW)
"
Note: Do not adjust items 6 and 7.
(GV-6D BOW)
"
1 2 3
Line-interval Center-line Adjustment
GV-SIZE GV-LIN
" "
� Adjust so that the intervals of the green horizontal lines at the top and bottom of the screen are symmetrical and correct.
GV-MID SIZE
"
4 5 6
GV-MID LIN
"
(GV-5D SIZE) (GV-6D LIN)
"
Note: Do not adjust items 5 and 6.
� Screen
� STATIC
1
Key No.
» Screen�s changes in the vertical direction when manual convergence adjustment is mode The changes at the arrow parts shown below are those implemented using the Volume ± key. Changes are opposite to the arrow when the Volume � key is used.