Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 5 (kliknij aby zobaczyć)
�65 TWIN REVERB REAR PANEL FUNCTIONS
A. GROUND SWITCH - Set the GROUND SWITCH to the position that produces the least amount of �buzz� or �hum� from the speakers. B. FUSE-The fuse is in the AC supply of the amplifier and will help to protect the amplifier and operator in the event of an electrical fault. If a fuse blows, it should only be replaced with a fuse in accordance with the listing at the fuse holder. If the amplifier repeatedly blows fuses, it should be checked out by a qualified technician. UNDER NO CIRCUMSTANCES should a fuse of a different type, higher current rating, or a fuse bypass be used, as this could damage the equipment and present a serious safety hazard. C. POWER SWITCH-This switch turns the AC power ON and OFF. When the switch is OFF, the amplifier is completely shut down. D. STANDBY SWITCH-This switch turns the amplifier on and off. In the STANDBY position, the amplifier is off; however, power is applied to the tube filaments so as to eliminate warm-up time. Use of this feature during short breaks versus using the POWER SWITCH will increase tube life. E. MAIN SPEAKER JACK- Plug-in connection for speakers. This jack must always be used as the primary connection to speakers. F. EXTERNAL SPEAKER JACK- Plug-in connection for an external speaker. This jack is wired in parallel with the MAIN SPEAKER JACK, and must only be used in conjunction with the MAIN SPEAKER JACK. Should the EXTERNAL SPEAKER JACK be used without also using the MAIN SPEAKER JACK, there will be no sound. Note that the amplifier is optimized for a 4 ohm speaker load, and that the speakers in the cabinet are wired for 4 ohms. Should a total load of more or less than 4 ohms be used, the amplifier will not put out its maximum power output before distortion occurs. G. FOOTSWITCH JACK- Plug-in connection for the footswitch. The footswitch allows you to turn the VIBRATO and REVERB features on and off without having to operate the controls on the front panel. Note that only the REVERB feature will operate without plugging in the footswitch. H. VIBRATO SWITCH-Push on, push off switch that turns the VIBRATO feature on and off. I. REVERB SWITCH -Push on, push off switch that turns the REVERB feature on and off.
