jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 106 (kliknij aby zobaczyć)
Code No.
Setting (The default is Highlighted ). <Delete Account> Delete an account (access number) which has previously been stored. <Procedure> 1. Enter �3� from the KEYPAD. (Display: A-3) 2. Press the START. This will blank out the Display. � If no accounts are yet to be programmed, the contents of the Display alternate between �A-3� and �blank.� 3. Press the RE to display the account to be deleted. 4. Press the START to delete the account. <Change Account> Change an access number which has previously been programmed. <Procedure> 1. Enter �4� from the KEYPAD. (Display: A-4) 2. Press the START. This will blank out the Display. � If no accounts are yet to be programmed, the contents of the Display alternate between �A-4� and �blank.� 3. Press the RE to display the access number to be changed. 4. Press the START to validate the access number displayed. 5. Enter a new access number from the KEYPAD. 6. Press the START to validate the new access number just entered. � If the new access number just entered already exists, �Err� appears on the Display and then the Display blanks out. In this case, perform steps 5 and 6 again. <Total Counter Display by Account> Display the count of the Total Counter for each account. <Procedure> 1. Enter �5� from the KEYPAD. (Display: A-5) 2. Press the START. This will blank out the Display. � If no accounts are yet to be programmed, the contents of the Display alternate between �A-5� and �blank.� 3. Press the RE to display the access number. 4. Press the START to validate the access number displayed. 5. Press the START. This will allow the Total Counter value to be displayed. E.g.: �123� and �456� alternate if the count is 123,456. 6. Press the CLEAR to clear the count. If the count is mistakenly cleared, press the INTERRUPT, which will restore the count just cleared. <Total Counter Clear for All Accounts> Clear the Total Counter counts for all accounts. <Procedure> 1. Enter �6� from the KEYPAD. (Display: A-6) 2. Press the START. Then, �CLr� appears on the Display. 3. Press the START again to clear all counts.
