Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 17 (kliknij aby zobaczyć)
ENGLISH
17
C
4
Remove and clean one set of cutters and combs at a time.
C
5
Separate the cutter from the comb and rinse clean under hot water.
Do not clean more than one cutter and comb at a time, since they are all matching sets. If you accidentally interchange the cutters and combs, it could take several weeks before optimal shaving performance is restored.
C
6
Replace the set back into the Razor Head Assembly so that the �wings� on the comb fit within the brackets located towards the center of the Assembly.
The set will only fit into the Razor Head Assembly if the �wings� are between the brackets. Make sure that the two pointy edges of the head fit exactly into the recesses.
7
Repeat the process for the other two sets of cutters and combs. Replace the frame. Press down (1) and turn wheel clockwise (2) until it locks into place. Close the Razor Head Assembly.
