To operate air conditioner with remote control
POWER ON/OFF
AutoCool
Cool
Turbo
Fan Only FAN SPEED Power Saver
High
NOTE: Two AA batteries (not included) power the remote control. Replace batteries after six months of use, or when the remote control starts to lose power. Be sure to install batteries with correct polarity.
To select the mode: Press the AutoCool, Cool, Fan Only, or Power Saver button. When air conditioner is operating in AutoCool mode, fan speed is adjusted automatically. When air conditioner is operating in Fan Only mode, fan speed is automatically set at Turbo. When air conditioner is operating in Cool or Power Saver mode, you can adjust the fan speed.
AutoCool
Cool
Fan Only
Power Saver
Low
Turbo
To select the fan speed (in Cool or Power Saver mode only): Press the Turbo, High or Low button.
Temp / Time Timer
High FAN SPEED Low
To set Timer for a 1 to 24 hour delay until air conditioner turns on (air
Timer
To turn the air conditioner on or off: Press the POWER ON/OFF button. To raise the temperature: Press thevbutton. Each time you press or hold thevbutton, the temperature will go up 1° until it reaches 86°F (30°C).
POWER ON/OFF
conditioner must be in OFF mode): 1. Press the Timer button. 2. Press thevbutton to change delay time (1 to 24 hours). 3. Press the Timer button again or wait 10 seconds. To set Timer for a 1 to 24 hour delay until air conditioner turns off (air conditioner must be in ON mode): 1. Press the Timer button. 2. Press thevbutton to change delay time (1 to 24 hours). 3. Press the Timer button again or wait 10 seconds.
Temp / Time
To lower the temperature: Press thewbutton. Each time you press or hold thewbutton, the temperature will drop 1° until it reaches 64°F (18°C). NOTE: In the event of a power failure, your air conditioner will operate at the previous settings when the power is restored.