REPLACING PHOTOCONDUCTOR UNIT (PCU)
When �Change Photoconductor unit� appears on the panel display, it is time to replace the photoconductor unit.
RWARNING:
Do not incinerate the photoconductor unit. Toner dust might ignite when exposed to open flame. Dispose of the used photoconductor unit according to local regulations for plastics.
NOTE: Do not tilt the used PCU after removing it from the machine. If you do, toner might fall out. NOTE: Do not hold the developer cartridge when removing the used PCU from your machine. If you do, the cartridge might come unlocked and fall. NOTE: Do not touch the photoconductor (green material). If you do, abnormal copies might be made. NOTE: Before you remove the used PCU from the machine, wait until the machine has completely stopped and is making no sound. Failure to take this precaution could result in a fault. NOTE: If there are misfeeds, remove the misfed paper before removing the used PCU. NOTE: Be sure to remove the sealing tape before setting the new PCU. Leaving it on could cause a fault. NOTE: After replacing the PCU, the machine will take about 2 minutes to initialize. During this period, do not open the front cover or turn off the main switch. If you do, a fault might occur.
1 2
Open the front cover. Turn the lever B1 to the left.
