jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 220 (kliknij aby zobaczyć)
FILM PROJECTOR UNIT (A846)
24 February, 1999
[I]
[A] [D] [B] [E]
[C]
[F]
[H]
[G]
A846I503.WMF
9. Set the film strip holder [A] into the film projector unit at the base film setting position. NOTE: Push the film strip holder lightly to confirm that the film strip holder is set correctly. 10. Turn on the test switch [B] on the projector control board and turn on the projector unit main switch [C].
øCAUTION
The lamp housing and reflector [D] will become very hot. The lamp cooling fan [E] will start turning suddenly when the lamp housing temperature becomes high. Keep hands away from these components to avoid any injury. 11. Loosen the wing nut [F]. 12. Adjust the position of the projected light by turning the dial [G] with a hexagon wrench [H] until it is at the center of the 4" x 5" frame [I] which is reflected in the mirror unit. 13. Tighten the wing nut [F]. 14. Turn off the projector main switch and the test switch. 15. Reinstall the lamp cover and other covers.
3-52
