Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 82 (kliknij aby zobaczyć)
INC
Making of self-made tool
the main PCB of repair parts. The making procedure is shown below. Make a self-made tool according to this procedure. This tool is the same one that was made for AF-S24-85/3.5-4. Use the same main PCB that was used for AF-S24-85/3.5-4G.
JAA78851-R.3617.A
� To inspect and adjust the output waveform of MR encoder, it is necessary to make a self-made tool by using
Use this range. Main PCB
â� Remove the mounted parts/elements (condenser, transistor, IC, etc.) from both sides of PCB, within the range of the left dotted lines . Do not remove the connector.
Connector
� Cut off the PCB along the dotted lines.
� Solder the wires on the PCB pattern at 4 parts as shown left.
GND MR-A
