RADIO You can use this set solely as a radio! 1 Adjust RADIO/ALARM to RADIO ON to switch on the radio. 2 Select your waveband by adjusting the BAND switch. 3 Adjust TUNING to tune to your desired station. 4 Turn the VOLUME control to adjust the volume level. 5 Adjust RADIO/ALARM to OFF to switch off the radio. To improve reception: FM: Extend and position the pigtail fully to obtain optimal reception. MW: Uses a built-in antenna inside the set. Direct the antenna by adjusting the position of your set. SETTING THE CLOCK AND ALARM TIME The time is displayed using the 24-hour clock. 1 Press and hold SET TIME or ALARM SET/OFF. 2 Press HOUR or MINUTE repeatedly, or hold down on the respective button to adjust the hours and minutes. 3 Release SET TIME or ALARM SET/OFF, and HOUR/MINUTE when you reach the correct setting. � The set clock time will show on the display and start to run. SELECTING THE ALARM MODE GENERAL If you wish to use the alarm, you must set the alarm time first. You can choose from two different alarm modes to wake you up: by radio or buzzer. � Select your choice of alarm mode by adjusting RADIO/ALARM to ALARM RADIO or ALARM - BUZZER. � The Alarm indicator lights up. Helpful hints: � If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you. � The buzzer is set at a fixed volume and cannot be adjusted.
