Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 9 (kliknij aby zobaczyć)
CD/ RADIO
Finding a passage within a track 1. During playback, press and hold down � or § y The CD is played at high speed and low volume; the display will show 'Cd:' and your current track number. 2. Release � or § when you recognize the passage you want. y Normal CD playback and standby clock time resumes. RADIO
SETTING ALARM OPTIONS
Radio Alarm: If you have selected the radio alarm, make sure you have tuned properly to a station.
2. Read the following section if you want to select the WAKE-UP TRACK alarm option.
Selecting CD WAKE-UP Alarm Mode You can program and select a CD track number between 1-99, when the set is in the standby or radio playback mode. However, if the track number programmed does not exist on your CD, the CD will start playback from the first track during the alarm call. 1. Set the alarm time for AL1. 2. Insert a CD into the CD compartment. 3. Press AL 1 to select CD alarm mode. 4. Press WAKE-UP TRACK to activate favorite track programming. 5. Press � or § until the desired track number is shown. 6. Press WAKE-UP TRACK to confirm the selected track number. y display returns to standby clock time. The 7. If you want to review your programmed track number, press WAKE-UP TRACK
1. Press RADIO ON (FM/ AM) to switch on the
radio. Display shows 'tu' before returning to clock y
time. 2. Press RADIO ON (FM/ AM) again if you wish to change waveband. 3. Adjust the sound using 4 or 3
4. Adjust the TUNING wheel to tune to a radio station.
To improve reception: FM: Extend coil antenna at the back of the unit fully for optimum reception. AM: Uses a built-in antenna. Direct the antenna by adjusting the position of your set.
5. Press ALARM RESET to switch off.
SETTING THE ALARM OPTIONS GENERAL Two different alarm times, AL 1 and AL 2 can be set in the CD, radio or buzzer modes. Selecting the Alarm Mode Options When selected, the selected alarm mode is shown in the display, and the respective AL 1 or 2 button lights up. 1. Select your choice of alarm mode. Either press briefly: � AL1 once for CD alarm . This enables CD playback from the first track as your alarm call. � AL2 once or more for radio / buzzer alarm
AL TIME 2
Note: � The buzzer alarm option will automatically replace the CD alarm if you have: � inserted a CD incorrectly; � inserted a damaged CD; � forgotten to insert any CD; � not closed the CD door properly.
