Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 13635 (kliknij aby zobaczyć)
1-21. T1 Loading Arm Unit Replacement & Adjustment
(Removal) Remove the cylinder Unit. (Refer to item 1-1) Move the T1 Post to loading direction by manual ejecting method until the screw (D) can be removal position as shown in Figure 1-19. 3. Unscrew the 2 screws (A) and (C), then remove the S1 and T1 Post from Loading Rail as shown in Figure 1-19. 4. Unscrew the 2 screws (D) and (E), then remove the Loading Rail as shown in Figure 1-19. 5. Remove the T1 Loading Arm Unit as shown in Figure 1-19. (Installation) 1. Install the T1 Loading Arm Unit follow the removal steps in reverse order, then Phase Adjustment should be performed as follows. (Adjustment) 1. When install the T1 Loading Arm Unit, then the hole (A) should be matched hole (B) as shown in Figure 1-19. 2. After installation, confirm that the S1 and T1 Post moving smoothly on the Loading Rail. 3. Perform the T1 Loading Arm Height Adjustment. (Refer to previous item) 4. After perform the height adjustment, execute the Post Height Pre-Adjustment and Tape pass Adjustment. Note: This replacement should be performed simultaneously, replacement of Cylinder Unit. It is convenience for Replacement of T1 Loading Arm Unit. Figure 1-21 1. 2.
1-22. M-Cassette Brake Base Unit Replacement (Camera Recorder only)
(Removal) 1. Disconnect the all connectors on Servo P.C.Board. Unscrew the 4 screws (A) to remove the Servo P.C.Board as shown in Figure 1-22. 2. Unscrew the screw (A) to remove the Cassette Down Photo Unit. 3. Unscrew the screw (B) to remove the MLock/Release Piece Unit. 4. Unscrew the 2 screws (C) to remove the M cassette Brake Base Unit. Then pick up the pin of Eject Arm Unit. (Installation) 1. Install the new cassette Brake Base Unit according to the opposite procedures to
