WHIRLPOOL AKG957/WH/WP
Skrócona Instrukcja Obsługi

AKR 410-412-413-415-416-610-611 AKR 612-613-615-616 / AKG 957

PRODUCT SHEET CONTROL PANEL
A. Light switch. B. Speed selector switch.

1. 2. 3. 4.

Control panel. Grease filters (behind the extractor grille). Lighting unit. Pull-out steam deflector (not extractable on AKR 610).

REPLACING BULBS
1. Unplug the appliance or disconnect the mains power supply. 2. Pull out the steam deflector (a-Fig. 1). 3. Open the extractor grille (b,c,d-Fig. 1). 4. Remove the burnt-out bulb. Replace using 40W max E14 bulbs only. 5. Refit the extractor grille.
large amount of steam and fumes

small amount of steam and fumes medium amount of steam and fumes

FITTING OR RENEWING THE CARBON FILTER:
1. Unplug the appliance or disconnect the mains power supply. 2. Pull out the steam deflector (a-Fig. 1). 3. Open the extractor grille (b,c,d-Fig. 1). 4. Rectangular or circular carbon filter: Circular carbon filter - Fig. 2: Assembly: Fit the carbon filter over the motor protection grille - The reference mark on the edge of the carbon filter (e) must align with the arrow on the fan shroud (f), lastly turn clockwise. Disassembly: Turn anticlockwise. Rectangular carbon filter - Fig. 3: Assembly: (g) Locate the carbon filter on the back rings and (h) secure the carbon filter in front with the clips provided. Disassembly: Press the release buttons (f-Fig. 2) and pull the filter downwards. 5. Refit the extractor grille.

FIG.1

FIG.2

REMOVING AND RENEWING OR CLEANING THE GREASE FILTER:
1. Unplug the appliance or disconnect the mains power supply. 2. Pull out the steam deflector (a-Fig. 1). 3. Open the extractor grille (b,c,d-Fig. 1). 4. Remove the device securing the grease filter. 5. Remove the dirty grease filter. 6. After the grease filter has been replaced or cleaned (depending on model), refit the parts in reverse order, making sure the entire extraction surface is covered. 5019 100 75152

FIG.3

D

GB

F

NL

E

P

I

GR