WHIRLPOOL AKR 852 GY
Skrócona Instrukcja Obsługi

31833204.fm Page 10 Friday, May 5, 2006 11:22 AM

SAFEGUARDING THE ENVIRONMENT
1. Packaging Packaging materials are 100% recyclable and are marked with the recycling symbol .Dispose of the appliance in conformity with local environmental regulations. Packaging materials (plastic bags, polystyrene, etc.) can be dangerous for children and should be kept well out of their reach. 2. Product This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is scrapped suitably, you can help prevent potentially damaging consequences for the environment and health. The symbol on the product or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to a suitable collection centre for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further information on the treatment, recovery and recycling of this appliance, contact your competent local authority, the collection service for household waste or the shop where you purchased the appliance.

If the hood does not come pre-fitted with a mains plug, fit one that conforms to applicable standards or use a double-pole switch with a minimum breaking gap of 3 mm. Replacement of the power supply cable with power plug or flexible cable may only be carried out by an authorized Service Centre or a qualified electrician.

Cleaning the hood
Warning! Failure to remove oil and grease (at least once a month) could lead to fire. Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol.

Before using the hood
Please read these instructions carefully and keep them for future reference, in order to ensure best use of your hood. Packaging materials (plastic bags, polystyrene, etc.) can be dangerous for children and should be kept well out of their reach. Make sure the hood has not been damaged during transport. Installation, electrical connections and replacement of the power cable with plug or flexible cable must be carried out by a qualified technician in compliance with the current local regulations. This appliance is designed to be used only by adults.

Declaration of conformity
This product has been designed, manufactured and sold in conformity to the following standards: - safety objectives of �Low Voltage� Directive 73/23/EEC - protection requirements of �EMC� Directive 89/336/EEC amended by Directive 93/68/EEC.

Troubleshooting guide PRECAUTIONS AND GENERAL RECOMMENDATIONS
The hood does not work: � Is the plug properly inserted in the power socket? � Is there a power failure? � Is the fuse blown? The hood is not extracting efficiently: � Is the right speed selected? � Do the filters need cleaning or replacing? � Are the air outlets blocked? The light does not work: � Does the bulb need replacing? � Is the bulb correctly fitted? � Is the fuse blown?

WARNING! � Do not allow children or infirm persons to operate the appliance without supervision. � Make sure children do not play with the appliance. 1. Do not connect the appliance to the mains electricity supply until installation is completed. Always disconnect the hood from the mains before performing any cleaning or maintenance. 2. Do not �flambé� food under the hood. Naked flames could cause a fire. 3. Do not leave pans unattended when frying. Cooking oil can catch fire. 4. Regular cleaning and maintenance is essential to correct functioning and good performance. Regularly remove dirt deposits. Regularly clean or replace filters. Never use flammable materials as hoses for extracted air. 5. If the hood is used together with non-electrically powered appliances, ambient negative pressure must not exceed 4Pa (4 x 10-5 bars). Make sure the room is adequately ventilated. 6. If the hood is used in extractor mode together with cookers, ambient negative pressure must not exceed 4 Pa (4 x 10-5 bars). 7. Exhaust air must not be conveyed through the same flue used by the heating system or other non-electrical appliances. 8. The room must be adequately ventilated when the hood is used together with appliances powered by gas or other fuels. 9. When replacing the bulbs, first ensure that they are cold. Note: always wear work gloves for all installation and maintenance operations

AFTER-SALES SERVICE
Before calling the After-sales Service 1. Check if you can fix the problem yourself (see �Troubleshooting guide�). 2. Switch the hood off and then on again to check if the problem has gone. 3. If the problem persists, contact the After-sales Service. Specify: � the nature of the problem, � the model of hood, stated on the data plate inside the hood, accessible by removing the grease filters. � your full address, � your telephone number and area code. � the service code (the number appearing below the word SERVICE on the data plate inside the hood behind the grease filter). If any repairs are needed, contact an authorised Service Centre (to ensure that only original spare parts are used and that repairs are made correctly). Failure to comply with these instructions may compromise the safety and quality of the product.

Electrical connections
Before connecting the hood to the power supply, make sure the voltage specified on the dataplate matches that in your home. The dataplate is located inside the hood behind the grease filter. If the appliance is fitted with a power cable and plug, the plug must be placed in an accessible position.

5019 318 33204

D

GB

F

NL

E

P

I

GR

S

N

DK FIN