|
|
|
Kto jest w sklepie?
Sklep przegląda 5869 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
4) Remove the TD cartridge from the bag. Remove the protective paper. Hold the cartridge on both sides and shake it horizontally four or five times.
7. Loading copy paper
Note: This copier is equipped with two paper trays. Load copy paper into the two paper trays. 1) Raise the handle of the paper tray and pull the paper tray out until it stops.
4 or 5 times
5) Hold the tab of the protective cover and pull the tab to remove the cover. 2) Remove the pressure plate lock. Rotate the pressure plate lock in the direction of the arrow to remove it while pressing down the pressure plate of the paper tray. 3) Store the pressure plate lock which has been removed in step 2 and the screw which has been removed when unpacking in the front of the paper tray. To store the pressure plate lock, rotate the lock to fix it on the relevant location. 4) Adjust the paper guides on the paper tray to the copy paper width and length. Squeeze the lever of paper guide (A) and slide the guide to match with the width of the paper. Move paper guide (B) to the appropriate slot as marked on the tray.
6) Gently insert the TD cartridge until it locks in place.
Paper guide (B)
Paper guide (A)
7) Close the front cover and then the side cover by pressing the round projections near the side cover open button. The indicator will go out and the ready ( ) indicator will light up. Note: When closing the covers, be sure to close the front cover securely and then close the side cover. If the covers are closed in the wrong order, the covers may be damaged.
5) Fan the copy paper and insert it into the tray. Make sure the edges go under the corner hooks. Note: Do not load paper above the maximum height line ( ). Exceeding the line will cause a paper misfeed.
6) Gently push the paper tray back into the copier. Note: After loading copy paper, to cancel the blinking "H" without restarting copying, press the clear ( ) key. The "P" in the display will go out and the ready ( ) indicator will light up.
AL-1551 UNPACKING AND INSTALLATION 5-3
|
|
|
> |
|
