Installation
Attaching the Rubber Feet (Included Items)
Attach these as required, such as when you�re using the AR-200S without mounting it on a rack or the like. Peel off the double-sided tape from the rubber feet and affix the rubber feet at the locations shown in the following figure.
fig.Set-01
Rack-Mounting the AR-200S
By attaching a rack mount adaptor (RAD-50: sold separately) to the AR-200S, you can install it in an EIA rack. One RAD-50 can accommodate up to two AR200S units. 1. Remove the four rubber feet from bottom of the unit. Note: Do not use these holes.
fig.Set-02.e
2.
Attach the RAD-50 adaptor to the AR-200S using the screws that are supplied with the RAD-50.
Rack Mounting (Important Notes on Heat Radiation)
When you are mounting the unit on a rack or the like, give attention to the following points to ensure efficient cooling. � � � Install in a well-ventilated location. Avoid mounting in a sealed rack. Warm air within the rack cannot escape and is sucked into the unit again, making efficient cooling impossible. When you are using a stacked mounting arrangement, be especially sure to provide for adequate ventilation within the rack to keep discharged air from being sucked back into the unit. If the back surface of the rack cannot be kept open, then provide a ventilation port or ventilation fan at the upper area of the back surface of the rack, where warm air accumulates. � When you are using the unit in a portable case or rack, remove the covers from the front and back surfaces of the case, so that the front and back surfaces of the unit are not obstructed. When placing the unit on the rack, be careful not to pinch your fingers. For more information about installation, also see �Placement� in the Important Notes (p. 3).
fig.Set-03
RAD-50
Attaching the Card Protector
By attaching the Card Protector (supplied) to the AR-200S, you can prevent the memory card from inadvertently being removed from the AR-200S. 1. After confirming that the card is securely inserted in the card slot, use the provided screws to attach the Card Protector, as shown in the figure below.
