SHARP ARFX5
Instrukcja Obsługi

SENDING A FAX

Using the auto document feeder

Using the document glass

7 Press the START key.
Scanning begins. If a job is not in progress and the telephone line is not being used, the destination is called after the first page is scanned. Transmission takes place as the document pages are being scanned. (This is called "Quick on-line"-refer to the following page.) If there is a previously stored job or a job is in progress, or if the line is being used, all pages of the document are scanned into memory and stored as a transmission job. (This is called memory transmission: the destination is automatically called and the document transmitted after previously stored jobs are completed.) If scanning is completed normally, the machine makes a beep sound to inform you that the transmission job is stored and JOB STORED appears in the message display.

7 Press the START key.
The original is scanned and the READ-END key appears.

2
8 If you have another page to scan, change pages
and then press the START key.
Repeat this sequence until all pages have been scanned. You can change the resolution and exposure settings as needed for each page (refer to pages 1-9 and 1-10). If no action is taken for one minute, scanning automatically ends and the transmission job is stored.

9 After the final page is scanned, touch the READEND key.
The machine makes a beep

L.

(Pg.No.

3)

sound to inform you that the transmission job is stored and JOB STORED appears in the message display. (The destination is

ESS [READ-END].
READ-END

automatically called and the document transmitted after previously stored jobs are completed.) Open the document glass cover and remove the document. NOTES � Canceling transmission To cancel transmission while SCANNING ORIGINAL... appears in the display or before the READ-END key is pressed, press the C key or the CA key. To cancel a transmission job that is already stored, press the JOB STATUS key and cancel the job as explained on page 2-6. � If the machine makes two beeps during or at the end of transmission and an error message appears in the message display, refer to page 7-3 to fix the problem. � If the power is turned off or a power failure occurs while a document is being scanned in the auto document feeder, the machine will stop and a document jam will occur. After power is restored, remove the document as explained on page 29 of "Operation manual (for copier)".

2-3