|
Dla tego produktu nie napisano jeszcze recenzji!
CARE AND MAINTENANCE
� Periodically clean air vents and the condenser at the rear of the appliance with a vacuum cleaner or a brush. Clean the outside using a soft cloth.
� 1. 2. 3. 4.
Prolonged disuse
Empty the refrigerator. Disconnect the appliance from the mains. Defrost and clean the interior. Leave the door open to prevent oxidation and the formation of mould and unpleasant odours. 5. Clean the appliance. � Clean the low temperature compartment interior (if present) during the defrosting operation. � Periodically clean the inside of the refrigerator compartment with a sponge moistened with warm water and/or neutral detergent. Rinse and dry with a soft cloth. Do not use abrasive products. � Clean the outside with a soft cloth moistened with water. Do not use abrasive products, scouring pads, stain removers (e.g. acetone, trichloro-ethylene) or vinegar.
.
TROUBLESHOOTING GUIDE
1. The appliance is not working. � Is there a power failure? � Is the plug properly inserted in the socket? � Is the mains power switch set to ON? � Has the fuse blown? � Is the power cord in perfect condition? � Is the thermostat set to z (Stop)? 2. Temperature inside the compartments is not low enough. � Is the door closed properly? � The food is stored inside the appliance incorrectly and obstructs proper closing of the door? � Is the appliance installed next to a heat source? � Is the thermostat setting correct? � Are the air circulation grilles blocked? 3. Temperature inside the refrigerator compartment is too low. � Is the thermostat setting correct? 4. The appliance is excessively noisy. � Has the appliance been installed correctly? � Are the pipes at the back touching or vibrating? 5. Water collects at bottom of refrigerator compartment. � Is the defrost water drain blocked? 6. Excessive frost build-up in the low temperature compartment. � Is the door closed properly? � Does the food stored inside obstruct proper closing of the door? Note: � Gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
65
|
