|
|
|
Kto jest w sklepie?
Sklep przegląda 6007 gości i
3 zarejestrowanych klientów |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
D. Setting related to fusing
1) Put down the right and the left levers of the fusing unit in the arrow direction.
F. Automatic developer adjustment
1) Attach the cabinets which were removed. 2) Close the left door and the front door. 3) Insert the power plug into the power outlet. 4) While pressing the [MENU] key and the [OK] key, turn on the power switch, and the machine will enter the diag mode. 5) On the operation menu, select "AUTOMATIC DV AD." (LCD Display)
AUTOMATIC DV ADJ. 128
6) Press the [OK] key, and the automatic developer adjustment will be performed. During execution of the automatic developer adjustment, the data (LED) blinks and the LCD indicates the toner sensor value. 7) After about 2 min, the adjustment value is stored in the machine. Check that the mode was normally completed. Normal end: The data LED goes off. Abnormal end: The error LED lights up. Remove the cause of the error, and execute the automatic developer adjustment again. 8) Turn off/on the power, and the machine returns to the normal mode and enters the warm-up mode.
E. Paper setting
1) Pull out the first stage paper feed tray. Slowly pull out the tray until it stops.
G. Print test
1) After completion of warm-up (normal mode), Press the [MENU] key to display "USER SETTING." 2) Press the [OK] key to select the menu. 3) Use [ ] and [ ] keys to select List Print, and print the user setup list to check the print quality. 4) Press the [MENU] key again to return to the normal menu.
5. Option expansion memory installation
A. Hard disk (ARHD3), print server card (AR-NC5J), expansion memory (commercially available one)
Note: Before performing this installation work, check that the data lamp on the operation panel is neither lighting nor blinking. 2) While pressing the paper holding plate, remove the fixing pin. 1) Turn off the power of the machine and disconnect the power plug from the power outlet. 2) Remove all the cables (such as printer cables) from the control PWB.
In the case of the printer control PWB In the case of the MFP control PWB
3) Put paper in the tray, and close the paper feed tray.
AR-P350 UNPACKING AND INSTALLATION 6-4
|
|
|
> |
|
