|
|
|
Kto jest w sklepie?
Sklep przegląda 5642 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
AR-PB2 10) Remove the securing screws holding the P side OP cover in the rear lower cover which was removed in the step 2, then remove the P side OP cover. Next, paste an attached label at the position only for Sweden and Norway as shown in the illustration.
P side OP cover
Wire saddle
Label Securing screws
Printer relay cable
(2) Expansion memory installation
a. Memory expansion in the printer control PWB 11) Hook the rear lower cover on the securing screw 4 which was loosened in the step 1 as shown in the illustration. Next, tighten the securing screws 1, 2 and 3 temporarily, which were removed in the step 2 and tighten the securing screw 4 which was loosened, tighten the securing screws 5, 6 and 7. Reinstall the rear cover tighten (which was removed in the step 2) to the original position by putting it onto the securing screws 1, 2 and 3 which temporarily secure the rear cover, then tighten the securing screws 1, 1 and 3 after tightening the securing screws 8 and 9.
Securing screw
Normally there is no need for memory expansion. However, memory expansion will increase the printer performance. When printing graphics or complex data, memory expansion will increase printing speed. Memory of 16MB or 32MB can be installed to the two slots. (16MB onboard) Different capacity of memory can be installed to the two slots. The total memory after expansion may be 32, 48, 64, or 80MB. After the above procedure, select VM Option menu and set the total memory capacity. b. ICU PWB memory expansion The copier ICU PWB requires total memory capacity of 16 (20)MB or more. Memory of 16MB or 32MB can be installed to the two slots. (4MB onboard) Different capacity of memory can be installed to the two slots.
Rear cover
Loosened screw Rear lower cover Securing screws
B. Stand-alone environment (Printer (parallel) cable connection)
Plug the connector of the Centronics cable (sold separately) into the Centronics port on the printer box base.Plug the other connector into the laser printer port on a personal computer.
12) If equipped with the RADF/ADF/SPF, reinstall the connector that was removed in the step 2 to the original position on the main copier unit, then secure with screws attached to the connector.
Connector going to the laser printer port on the personal computer
Centronics cable (sold separately)
Screw Connector
1 Connect the printer relay cable to the connector of printer box. 2 Attach the packaged wire saddle to the printer relay cable. 3 Insert and attach the wire saddle at the position of rear lower cover as shown in the illustration.
3�3
|
|
|
> |
|
