...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Tekstowy podgląd strony 3 (kliknij aby zobaczyć)
2) Remove the rear cabinet of the copier.
Remove the seven screws and remove the cabinet. Remove the connector cover.
6) Attach the cushion (one position).
Remove the cover of the double-sided adhesive tape and paste the cushion taking care not to allow it to extend over the plate edges.
�
If a open/close detection is attached, be careful not to break the actuator.
3) Remove the right cabinet.
Remove the five screws.
7) Attach the SPF glass holder cover.
After attaching the SPF glass holding cover, attach the document glass.
4) Remove the document glass holder (left side) and the document glass.
Remove the two screws and carefully remove the document glass holder (left side) and the document glass. Do not separate the glass and holder.
8) Remove the PWB shield plate.
Remove the six screws.
5) Remove the document glass holder cover (right side).
Remove the two screws.
