JVC AV-21RM4SE
Instrukcja Obsługi

Via the Euroconnector

Tips
Clean the screen with a slightly damp, soft cloth. Do not use abrasive solvents as they may damage the TV screen coating layer.

Your TV set has an Euroconnector socket. If you want to connect equipments (e.g. video recorder, decoder, etc.) which Care of the Screen: have Euroconnectors, to your TV, use the AV-1 (EXT.I) or AV-1 S (EXT.I) terminals.

AV-1 S Mode
If the equipment connected to your TV set supports S-Video (Y/C) output from Euroconnector, you can have a better picture quality by selecting AV-1 S mode and connecting your equipment to the AV-1 S (EXT.I) terminal of TV. See your equipment's booklet to check if your equipment has such feature.

Poor Picture:
Have you selected the correct TV system? Is your TV set or house aerial located too close to the loudspeakers, nonearthed audio equipment or neon lights, etc. ? Mountains or high buildings can cause double pictures or ghost images. Sometimes you can improve the picture quality by changing the direction of the aerial. The picture quality may degrade when two peripherals are connected to the TV at the same time. In such a case, disconnect one of the peripherals.

Via the RCA jacks
If you have an equipment (such as a Camcorder) which has the RCA jacks, connect it to the F-AV (Front AV) terminal with the video and audio cables.

No Picture:

Via the ANT (aerial) socket

Is the aerial connected properly? Are the plugs connected If your equipment does not have an Euroconnecter or RCA tightly to the aerial socket? Is the aerial cable damaged? Are jacks, connect it to the TV with an aerial cable. For details, suitable plugs used to connect the aerial? If you are in doubt, see the manual provided with the equipment. consult your dealer. No Picture means that your TV is not receiving any trans� To store the test signal that comes from the equipment, see mission. Have you pressed the correct keys on the remote "Install. Menu" on page 7 and store it to the programme control? Try once more. number 0. You can watch images from that equipment to select the programme number which you stored the test Remote Control: signal. Your TV no longer responds to the remote control. Press the

TV and Video Recoder (VCR)
� Connect the Video Recorder to the ANT (antenna input) socket of the TV with the aerial cable. � Connect the Video Recorder to the AV-1 or AV-1 S terminal with the SCART cable, or connect it to the F-AV (Front AV) terminal with the audio and video cables.

�STANDARD� button on the remote control once more. Perhaps the batteries are exhausted. If so you can still use the local buttons at the front of your TV. Have you selected the wrong menu? Press �STANDARD� button to return to TV mode or press �MENU� button to return to the previous menu.

No solution:
Switch your TV set off and on. If this does not work, call the service personnel; never attempt to repair it yourself.

NTSC Playback
Connect a NTSC video recorder to a terminal. Then press �AV� button to select the corresponding AV mode. NTSC 3.58/4.43 system is detected automatically in AV mode.

Connecting Headphones
Use the headphone socket of your TV, to connect headphones.

ENGLISH - 11 -