Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 10 (kliknij aby zobaczyć)
Quick Setup
Getting Started
Getting Started
These quick setup pages will provide you, in three easy steps, with the basic information you need to begin using your new television right away. If you have questions, or for more detailed information on any of these steps, please consult other sections of this manual.
Step 1 � The Remote Control
Before you can operate your remote control, you first need to install the batteries (included). With your thumb, push the latch on the back of the remote control inward, and while holding it there, pull the battery cover out with your index finger. Insert the battery (included) carefully noting the �+� and ��� markings. Push the cover back into place.
HIN A
M AD EIN C
ER Y
L ITH IN S IUID MB ET AT
S EE
M 2A
NU
AL
Key Feature Buttons
The four key feature buttons at the center of the remote can be used for basic operation of the television. The top and bottom buttons will scan forward and back through the available channels. To move rapidly through the channels using JVC�s Hyperscan feature, press and hold CH+ or CH�. The channels will zip by at a rate of five channels per second. The right and left buttons will turn the volume up or down. These buttons are also marked with four arrows and are used with JVC�s onscreen menu system. To use the onscreen menus, press the MENU button.
MUTING
1
C R
20
C.C.
25
CH VOL MENU CH
VOL EXIT
Note: Illustration of remote control RM-C203G
Basic Operation
POWER
Turn the television on and off by pressing the POWER button at the top right corner of the remote.