Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 27 (kliknij aby zobaczyć)
xLEVEL You can vary the level of each speaker as follows. The default settings are underlined. � C. LEVEL 0 dB (centre speaker level) Adjust the level of the centre speaker (you can adjust from �10 dB to +10 dB in 1 dB steps). � R. LEVEL 0 dB (rear speakers level) Adjust the level of the rear speakers (you can adjust from �10 dB to +10 dB in 1 dB steps). � SW. LEV. 0 dB (subwoofer level) Adjust the level of the subwoofer (you can adjust from �10 dB to +10 dB in 1 dB steps). Notes
� When you select an item, the sound cuts off for a moment. � Depending on the settings of other speakers, the subwoofer may output excessive sound.
Getting Started
To adjust the volume of all the speakers at one time Use the VOLUME control. Other AMP MENU settings You can control the brightness of the front panel display, clear the preset stations and the station names, and set the speaker parameters back to the default setting. Press AMP MENU repeatedly to display 9 CUSTOMIZE. Use X/x to select the following items. xDIMMER You can change the brightness of the front panel display by two ways. Use C/c to adjust the settings or press DIMMER. xMEMO. CLR. You can clear the preset stations and station names, and set the speaker parameters back to the default setting. � MEMO.CLR.N (No): Press ENTER to skip back to previous menu. � MEMO.CLR.Y (Yes): If you press ENTER, �Really? N� appears. To clear the memory, use C/c to select �Really? Y� and press ENTER. �ALL CLEAR!� is displayed and all settings such as preset stations and station names will be cleared, and speaker parameters will be reset to their default settings.
