|
|
|
Kto jest w sklepie?
Sklep przegląda 5917 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Section
Audio Adjustments
13
1 Touch A.MENU and AUDIO and then touch LOUDNESS. 2
# To turn loudness off, touch b.
Touch a to turn loudness on.
3 Touch c or d to select a desired level. Each time you touch c or d selects level in the following order: LOW (low)MID (mid)HIGH (high)
5 Touch b and then touch c or d to select cut-off frequency. Each time you touch c or d selects cut-off frequencies in the following order: 5080125 (Hz) Only frequencies lower than those in the selected range are output from the subwoofer.
Using non fading output
When the non fading output setting is on, the audio signal does not pass through this units low pass filter (for the subwoofer), but is output through the RCA output. 1 Touch A.MENU and AUDIO and then touch NON FADING.
Using subwoofer output
This unit is equipped with a subwoofer output which can be turned on or off. ! When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. 1 Touch A.MENU and AUDIO and then touch SUB WOOFER.
# When the subwoofer controller setting is only PREOUT FULL, you can select NON FADING. (Refer to page 75.)
# When the subwoofer controller setting is PREOUT FULL, you cannot select SUB WOOFER.
2
Touch a to turn non fading output on.
# To turn non fading output off, touch b.
2
# To turn subwoofer output off, touch c.
Touch d to turn subwoofer output on.
3 Touch b and then touch c or d to select the phase of subwoofer output. Touch d to select normal phase and NORMAL appears in the display. Touch c to select reverse phase and REVERSE appears in the display. 4 Touch b and then touch c or d to adjust the output level of the subwoofer. displayed as the level is increased or decreased.
3 Touch c or d to adjust the output level of the non fading. Each time you touch c or d increases or decreases the level of the non fading. +6 6 is displayed as the level is increased or decreased.
Audio Adjustments
Using the high pass filter
When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn the HPF (high pass filter) on. Only frequencies higher than those in the selected range are output from the front or rear speakers.
Each time you touch c or d increases or decreases the level of the subwoofer. +6 6 is
En
59
|
|
|
> |
|
