|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Section
Audio Adjustments
17
When tweeter is selected in the network mode
Parameter What it does Selects cut-off frequencies in the following order: 1.25k�1.6k�2k�2.5k�3.15k� 4k�5k�6.3k�8k�10k�12.5k (Hz) SLOPE PHASE Selects slopes in the following order: �12� �6 (dB/oct.) Switches the phase between NORMAL and REVERSE.
(high-pass filter). The cut-off frequency setting has no effect if the subwoofer is set to OFF and other speakers are set to LARGE or OFF. ! If trying to boost the bass output of the subwoofer doesn�t do much or rather makes you feel that the bass gets more murky, this may indicate that the subwoofer�s output and bass content you hear over other speakers cancel each other out. To remove this problem, try changing the phase setting for the subwoofer. ! You can store the adjusted setting in memory by using MEMORY. For details concerning operation, refer to Storing the adjusted audio settings in memory on page 96.
FREQUENCY
When front speaker HPF is selected in the network mode
Parameter What it does Selects cut-off frequencies in the following order: 50�63�80�100�125�160� 200 (Hz) Selects slopes in the following order: �18� �12� �6 (dB/oct.)
Using the time alignment
The time alignment lets you adjust the distance between each speaker and the listening position.
FREQUENCY
SLOPE
To switch the filter of the front speaker between LPF and HPF, touch HIGH PASS or LOW PASS.
Recalling time alignment settings
% Touch TIME ALIGNMENT on the sound setting menu to select the time alignment. Touch TIME ALIGNMENT repeatedly to switch between the following time alignment settings: INITIAL�AUTO�CUSTOM1�CUSTOM2� CUSTOM3�LAST MEMORY�OFF
# You can select LAST MEMORY only when the adjusted time alignment setting is not memorized in this unit. # You cannot select AUTO when NETWORK has been selected. (Refer to Switching the DSP setting mode on page 110.) # When STANDARD has been selected, you cannot select AUTO if auto TA and EQ has not been carried out.
When front speaker LPF is selected in the network mode
Parameter What it does Selects cut-off frequencies in the following order: 1.25k�1.6k�2k�2.5k�3.15k� 4k�5k�6.3k�8k�10k�12.5k (Hz) Selects slopes in the following order: �12� �6�0 (pass) (dB/oct.)
Audio Adjustments
FREQUENCY
SLOPE
# You can mute the selected speaker unit by touching MUTE OFF. To cancel muting, touch MUTE ON. Notes ! Selecting cut-off frequencies sets cut-off frequencies of the subwoofer�s L.P.F. (low-pass filter) and that of the SMALL speaker H.P.F.
En
93
|
|
|
> |
|
