|
|
|
Kto jest w sklepie?
Sklep przegląda 5845 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
AV-N65P74
1.2.1.2 DISASSEMBLY PROCEDURE � Make sure that the power cord is pulled out from the AC wall socket. (1) Remove the 2 screws [ A ] on the left rear side of the set, and then remove the rear cover bracket. [Fig.1] (2) Remove the 2 screws [ B ] inside of the front door. [Fig.2] * The screws attach the speaker panel. (3) Remove the 2 screws [ D ] on the left edge of the rear cover, and remove the 2 screws [ D ] on the right edge of the rear cover. [Fig.2] * The screws attach the speaker panel. (4) Pull the speaker grill in front direction, and remove the speaker grill. [Fig.2] (5) Remove the connector [CN00Z] for the auto-convergence sensor on the left side of the set, and the clamp fixing the wire. [Fig.2] (6) Remove the 2 screws [ A ] on the left front panel bracket, and remove the 2 screws [ A ] on the right front panel bracket. [Fig.2] (7) Remove 1 screw C on the left edge of the rear cover, and 1 screw C on the right edge of the rear cover. [Fig.3] (8) Remove 1 screw [ A ] on the left side of the rear cover, and remove 1 screw [ A ] on the right side of the rear cover. [Fig.3] (9) Move the rear cover approx. 3cm in rear direction. Then, remove the upper unit from the lower unit by lifting the upper unit slowly. [Fig.3] � VOID seal [ a ] attached to the left front panel bracket in order to confirm that a person except JVC installation workers has disassembled the set. This seal is removed when the upper unit is removed, and the letters of "VOID" appears in the place where the seal. [Fig.2] � Two or more people are required to move the upper unit. � Reflecting mirror is attached to the upper unit. So, handle it carefully so as to protect it from shocks. � In placing the upper unit on the ground, be careful not to insert the connector for the auto-convergence on the right side of the upper unit between the upper unit and the ground. � In placing the upper unit on the ground, be careful not to insert dust inside the upper unit. � Be careful not to hurt yourself because metal brackets for attaching the front panel are on the ceiling part of the lower unit. (10) Cover the lower unit with the Top Sheet in order not to insert dust in the lower unit. Top Sheet is the one used for package. [Fig.4]
a
D
A
CN00Z
D
B
Fig.2
SPEAKER GRILL
UPPER UNIT
A C
Fig.3
TOP SHEET
LOWER UNIT
A
REAR COVER BRACKET
Fig.4
Fig.1 (No.52126)1-5
|
|
|
> |
|
