Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 88 (kliknij aby zobaczyć)
1
2
3
4
- Removing the Display Assy (Fig.7)
Display Assy
A
Holder
1 2 3
Remove the two screws and then remove the Holder. Remove the three screws and then remove the Cover Unit. Remove the four screws.
1
1
3
3
Disconnect the connector and then remove the Display Assy.
B
3 2 2 2
3
Cover Unit
Fig.7 - Removing the Monitor PCB (Fig.8)
1
C
Straighten the tabs at two locations indicated.
1
1
2
Remove the screw.
Disconnect the connector and then remove the Monitor PCB.
D
2
Monitor PCB
Fig.8
Note: Tighten the screws with the panel in warped state as shown in the photograph below. Otherwise, it will be difficult to install Detach Grille Assy to Panel Assy.
E
