WHIRLPOOL AWG 874 PL
Instrukcja Obsługi

UntitledBook2.book Page 108 Wednesday, June 11, 2003 3:01 PM

WASHING PROGRAMME
Select the programme:
1. Check that the Programme Selector is on � �. 2.Plug in the appliance. 3.Open the tap. 4.Set the Programme Selector to the desired programme. 5. Press the �Spin Speed Reduction� button. � Every programme has an automatic predefined maximum spin speed. � Press the button to set another spin speed. The corresponding LED lights up. � If the spin speed �0� is selected, the final spinning is cancelled. The water is drained out only. 6. Depending on model, set the Spin Speed Selector knob to the desired spin speed. 7. Select the options desired by pressing the corresponding buttons. The button lights up when it is pressed. The �Start� button turns off and on again once the programme has started only. 8. Check that the door is well closed. Press the �On/Off� button. 9. The �Start� button is flashing. Press the �Start� button to start the programme.

Door lock

The door locks automatically after the programme start until the end of the programme. If the programme selector is moved to the � � position or if the electricity supply is interrupted, then the door is released after approximately two minutes. In this case do not open the door: because hot water could come out of the door.

Programme end
The end LED (programme phase indicator) is alight. The programme selector knob is at the � position. 1. Press �On/Off� button . 2.Turn off the tap. 3.Open the door and unload the machine. N.B. Do not fully close the door but leave it ajar to allow the drum to dry out. �

How to change or stop a programme during the washing cycle.
1. Check that the Programme Selector is on � �. 2.Set the Programme Selector to the desired programme. 3.Press the �Spin Speed Reduction� button. � Every programme has an automatic predefined maximum spin speed. � Press the button to set another spin speed. The corresponding LED lights up. � If the spin speed �0� is selected, the final spinning is cancelled. The water is drained out only. 4.Depending on model, set the Spin Speed Selector knob to the desired spin speed. 5. Select the options desired by pressing the corresponding buttons. The button lights up when it is pressed. The �Start� button turns off and on again once the programme has started only. 6. Check that the door is well closed. Press the �On/Off� button. 7. The �Start� button is flashing. Press the �Start� button to start the programme. Do not add detergent.

108

Black process 45.0° 100.0 LPI