Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 10 (kliknij aby zobaczyć)
REMOVING THE FILTER / DRAINING RESIDUAL WATER
WHEN TO REMOVE THE FILTER
� � � Check and clean the filter at least 2 or 3 times a year. When the appliance does not drain or spin properly. When the pump is blocked by an object (buttons, coins, safety pins).
2.
IMPORTANT: Before draining, make sure that the water has cooled.
REMOVING THE FILTER
1. Switch off the appliance (set the programme selector to �0�). 2. Open the filter cover using the coloured insert from the detergent drawer. 3. Place a tub or container beneath it. 4. Slowly turn the filter anticlockwise until its handle is vertical without unscrewing it completely. 5. Wait until all the water has drained. 6. Now unscrew the filter completely and remove it. 7. Remove any foreign material from the filter. 8. Check that the pump rotor moves freely. 9. Insert the filter and screw it in clockwise until it locks (until the grip is horizontal). 10. Close the cover. 11. Pour 1/2 litre of water into the detergent drawer to reactivate the Eco system. 12. Select the desired programme and hold down the Start button for about 1 second. 1. 3. 2. 8. 6. 4.
WHEN TO DRAIN RESIDUAL WATER
� � When transporting (moving) the machine. If there is danger of freezing in the installation room. In this case the machine should be drained after every wash.
DRAINING RESIDUAL WATER
The residual water drain hose (if provided) is located in the machine plinth. If the machine is not provided with a drain hose in the plinth, remove the filter to drain residual water (see �Removing The Filter�). 1. Lift the cover upwards with light pressure. 2. Pull out the hose by about 15 cm. Pull off its endcap.
3. Let the water drain into a flat container until the flow stops. Close the drain hose and replace it. 4. On next use, pour about 1 litre of water into the detergent drawer to reactivate the Eco system.
