Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 14 (kliknij aby zobaczyć)
3gb10146.fm5 Page 16 Tuesday, April 20, 2004 10:17 AM
INSTALLATION
Remove the transit bolts
1.Slacken the four bolts with the spanner supplied. 2.Unscrew the bolts by hand. 3.Holding the bolt head, pull each bolt through the wide
part of the holes. 4.Close the holes with the plastic covers supplied; insert the covers in the wide part of the hole and slide them toward the narrow part until they click into place. 5.Keep the transit bolts for future use. � Whenever the appliance is transported, the transit bolts must be refitted: 1.Pry off the plastic covers with a screwdriver, slide them in the opposite direction of the arrow and remove. 2.Insert the transit bolts, performing the steps for removal in reverse order.
Adjust the feet
If the floor is uneven, adjust the levelling feet as required (do not insert pieces of wood etc. under the feet): 1.Slacken the locknut using the spanner supplied. 2.Adjust the height of the foot, turning it by hand. 3.Tighten the locknut by turning it anti-clockwise towards the appliance casing. If the appliance is to be installed on a wooden floor, distribute the weight by placing it on a 60 x 60 cm sheet of plywood at least 3 cm in thickness. Secure the plywood sheet to the floor.
