WHIRLPOOL AWO 9663
Instrukcja Obsługi

30105536aGB.fm Page 25 Thursday, December 30, 2004 10:53 AM

TROUBLESHOOTING GUIDE
Depending on the model, your washing machine is equipped with various automatic safety functions. This enables faults to be detected in good time and the safety system can react appropriately. These faults are frequently so minor that they can be removed within a few minutes. The washing machine will not start, no indicator lamps are on. Check whether: � the mains plug is inserted into the socket � the wall socket is functioning correctly (use a table lamp or similar appliance to test it) The washing machine will not start... and the �Start/Pause� indicator lamp flashes. Check whether: � the door is properly closed (child safety); � the �Start/Pause� button has been pressed. In models with LCD display, the display shows: Residue from detergent and additives left in the detergent drawer at end of wash. Check whether: � the siphon is correctly installed and clean (see �Care And Maintenance�) � sufficient water is entering. The mesh filters of the water supply could be blocked (see �Care And Maintenance�) � When using powder detergent beforehand the coloured insert for dosing liquid detergent has been removed from the dispenser Machine vibrates during spin cycle. Check whether: � the washing machine is level and standing firmly on all four feet � the transit bolts have been removed. Before using the machine, it is imperative that the transport bolts are removed Final spin results are poor. � the water tap is closed. For models with a �Water tap closed� indicator lamp, the red indicator lamp lights up. Open the tap and press the �Start/Pause� button. The appliance stops during the programme (varies depending on model) Check whether: � the �Rinse Hold� indicator lamp is flashing; terminate this option by pressing the button again In models with LCD display: the �Rinse Hold� option has been preselected and the �Rinse Hold� symbol appears on the display; cancel this option by pressing the � � button or select the �Drain� programme � another programme has been selected and the �Start/Pause� indicator lamp is flashing. Reselect the desired programme and press the �Start/Pause� button � the door has been opened and the �Start/Pause� indicator lamp is flashing. Close the door and press the �Start/Pause� button again. In models with LCD display, the display shows: �PAUSE!� � the washing machine's safety system has been activated (see �Fault display chart�) 25 The washing machine has an imbalance detection and correction system. If individual heavy items are loaded (e.g. bathrobes), this system may reduce the spin speed automatically or even interrupt the spin completely if it detects too great an imbalance even after several spin starts, in order to protect the washing machine. In models with LCD display, in the event of an imbalance, the display shows:

� If the laundry is still too wet at the end of the cycle, add smaller articles of laundry and repeat the spin cycle � Excessive foam formation may prevent spinning. Use the correct amount of detergent In models with LCD display, the display shows:

� Check that the spin speed selector has not been set to �0�

Black process 45.0° 100.0 LPI