Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 11 (kliknij aby zobaczyć)
DRAINING RESIDUAL WATER
WHEN TO DRAIN RESIDUAL WATER
If the filter needs to be cleaned during a programme. Note: Make sure that the water has cooled before draining. � � When transporting or moving the machine. If there is danger of freezing in the installation room. In this case the machine and the hoses should be drained after every wash. � 6. Wait until the flow stops. 7. Fix again the drain hose on the rear side of the machine (see arrow B) otherwise there is the risk of leakage and the normal filling and draining functions of the machine cannot be guaranteed. 8. Replace the drain hose with the �U� bend and fix it.
DRAINING RESIDUAL WATER
1. Switch off the appliance. 2. Unplug the machine from the mains. 3. Unclip the drain hose connection on the rear part of the machine (see arrow A and B). 4. Place a container in suitable size beside the machine. Note: After a correct draining cycle the residual water amounts about up to 1 litre but there can be up to 20 litres of water in the machine if stopped during a programme and even 40 litres if the pump is blocked. 5. Lower the drain hose into a container and let the water drain. Note: Make sure that the water has cooled before draining.
WASHING MACHINE INSTALLED IN ROOM EXPOSED TO FREEZING TEMPERATURES
Drain residual water from the machine, and the inlet hose after every wash cycle. 1. Switch off the appliance. 2. Unplug the machine from the mains. 3. Close the tap, loosen the inlet hose from the machine and let the water drain out. 4. Open the filter, let the water drain out and close it again. Note: Before a new wash cycle screw the inlet hose to the machine by hand. Check watertightness of washing machine connections by turning the tap completely on.
