Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 9 (kliknij aby zobaczyć)
DRAINAGE SYSTEM
Direct drainage at the rear of the dryer
To avoid to empty the water container at the end of each drying cycle, connect the pipe supplied in the dryer directly to a fixed drain or put it into a sink. 1. Remove the pipe in the lower part behind the dryer and mount it to the plastic connector (shown in driagram), put a rag underneath to collect water spillage. 2. Connect the pipe supplied with the dryer to the connector. The maximum drain height is 1m. 3. Make sure that the pipe is not bent or twisted (the end of the pipe must not be immersed in the drain water to avoid risk of siphoning).
The supplied hose length is 1,5m. The maximum permitted length is 2,5m.
DOOR REVERSIBILITY
To change the direction of opening of the door 1. Unplug the dryer. 2. Open the door. 3. Remove the contact pin at the upper part of the door with a spanner. Turn the contact pin 90° and take it out. 4. Unscrew the 2 screws at the door hinge and remove the door. 5. To remove the door lock: � Unscrew the two screws above and below the door lock system and slide it upwards (1,5 cm) holding it from the bottom. Remove it. 6. To change the door opening: � Turn the door. � Re-fit the door with the 2 screws at the preferred position. � Insert the door lock system at the opposite side of the door and move it (1,5 cm) down. � Fix the 2 screws above and below the door lock system � Take care not to reverse the sense of the door lock system. The child safety must be above the locking mechanism. 7. Replace the contact pin in the top of the door.
MAINTENANCE
1. Wipe the cabinet with a mild household detergent. Avoid using abrasive cleaners. 2. Clean the lint filter at the end of each drying cycle. 3. If the lint filter mesh is clogged, clean it with water and a soft brush. 4. Clean the heat exchanger at least every three months proceeding as follows: � Open the door and press the button on the bottom of the door entrance. � � The heat exchanger flap opens. Rotate the retaining springs and extract the heat exchanger. 47
