BATTERIES
Whenever convenient, use the mains supply if you want to conserve battery life. Make sure you remove the mains plug from the set and wall socket before inserting batteries. Batteries (optional) 1. Open the battery compartment and insert as shown six batteries, type R20, or D-cells. 2. Replace the compartment door, making sure the batteries are firmly and correctly in place. 3. Remove the batteries if exhausted or if they will not be used again for a long period. Batteries contain chemical substances, so they should be disposed of properly. � The incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. Therefore: � Do not mix battery types, e.g. alkaline with zinc carbonate. � When inserting new batteries, replace all batteries at the same time.
Note: The battery supply is switched off when the set is connected to the mains.
MAINS
1. Check if the mains voltage as shown on the type plate (on the bottom of the set) corresponds to your local mains voltage. If it does not, consult your dealer or service organisation. 2. If your set is equipped with a voltage selector, set it to the local mains voltage. 3. Connect the mains lead to the MAINS socket and the wall socket. � The set is now ready to use. 4. To switch off the mains supply completely, pull the mains plug out of the wall socket. � Disconnect the mains lead when you change over to battery supply, or to protect the set during heavy thunderstorms.
Environmental information
All redundant packaging material has been omitted. We have done our utmost to make the packaging easily separable into three mono materials: cardboard (box), expandable polystyrene (buffer) and polyethylene (bags, protective foam sheet). Your set consists of materials which can be recycled if dissassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
