Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 7 (kliknij aby zobaczyć)
BA-210SP Bassamp Cube with Digital Effects
PROGRAMMING THE FOOTSWITCH:
The BA-210SP allows you to save four DSP settings by means of the two button footswitch supplied with the amplifier. Use the following steps to store and recall four DSP settings:
�Press the footswitch button until both LEDs are off � select an effect (bypass, �0�) � for reference, this shall be Preset A �Press the #1 button on the footswitch (the #1 LED illuminates and Preset A is stored) - select another effect (chorus, �1�) and adjust to taste � for reference, this shall be Preset B �Press the #2 button on the footswitch (the #2 LED illuminates and Preset B is stored) - select another effect (octawah, �11�) and adjust to taste � for reference, this shall be Preset C �Press the #1 button on the footswitch again (the #1 LED turns off and Preset B is stored) - select another effect (SVT, �12�) and adjust to taste � for reference, this shall be Preset D �Press the #2 button on the footswitch again (both LEDs are off and Preset D is stored) - Preset A is automatically recalled � without changing the setting of the Effects control. Selection of the effects is now controlled by the footswitch. NOTE: The footswitch presets will be retained within the amplifier even after turning the amplifier off, until the above steps are repeated using different effects settings.
