Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 32 (kliknij aby zobaczyć)
Something not working?
Problem
Possible cause
Solution
The water tap is closed (E10). Open the water tap. The water inlet hose is Check the whole length of the squashed or kinked (E10). hose and remove the kink. The small filter of the water Clean the filter. inlet hose is clogged (E10). The door is not properly closed (E40). The machine fills then empties immediately The end of the drain hose is too low. Close the door. Place the hose at the right height (see Installation section). Check the whole length of the hose and remove the kink.
The machine does not fill
The drain hose is squashed or kinked (E20).
The machine does not empty and/or does not spin The RINSE HOLD option (stop with water in drum) has been selected.
The drain filter or the Clean the filter or check drain hose are clogged (E20). the hose. Empty out the water by pressing the START button or selecting the DRAIN programme.
The laundry is not evenly Redistribute the laundry distributed inside the drum. manually in the drum. Too much detergent has been used. An unsuitable detergent has been used that creates too much foam. One of the connectors on the water inlet hose is leaking. The drain filter has not been properly screwed on after cleaning. Measure detergent according to the manufacturer�s instructions. Use a suitable washing machine detergent. Check that the hose is firmly screwed on at both ends. Fully screw the filter into place.
